KSB BoosterControl Advanced - 10 Parameter List

10 Parameter list
56 of 88
BoosterControl Advanced
10 Parameter list
Table57: Overview of parameters
Parameter Description Factory setting Possible settings min. value max. value Read access right Write access right
1 Operation
Display of operating mode
- - - - Everybody Nobody
1-1 System
General operating status indicators
- - - - Everybody Nobody
1-1-1 System pressure
Displaying the measured system pressure
- - - - Everybody Nobody
1-1-2 System load %
Displaying the total pump load in percent
- - - - Everybody Nobody
1-1-3 RDP switch
Detection of dry running protection via
pressure switch is activated/deactivated
- Not available,
available
- - Everybody Nobody
1-1-4 Inlet pressure
Displaying the suction-side pressure
- - - - Everybody Nobody
1-1-5 Level content in %
Displaying the water level in inlet tank in
percent
- - - - Everybody Nobody
1-1-6 Level height
Displaying the water level in the inlet tank
- - - - Everybody Nobody
1-1-7 Ambient temp. (WSD)
Displaying the measured ambient
temperature if water flow detection is
available
- - - - Everybody Nobody
1-1-8 Digital inputs
Displaying the status of the digital inputs
- - - - Service Service
1-1-9.2 Position suppl.valve
Position of supply valve
Open Open,
closed
- - Everybody Nobody
1-1-9.1 Position suppl.valve
Position of proportional supply valve
0% ... 100%
0 0...100 0 100 Everybody Nobody
1-1-10 Power down speed
Calculated stop speed if zero-flow
detection is activated in energy-saving
mode.
- - - - Service Nobody
1-1-14 WSD pulses tank 1
Water flow detection, number of fills in
tank1
0 - - - Everybody Nobody
1-1-15 WSD pulses tank 2
Water flow detection, number of fills in
tank2
0 - - - Everybody Nobody