3 Transport/Temporary Storage/Disposal
9 of 88
BoosterControl Advanced
3 Transport/Temporary Storage/Disposal
3.1 Checking the condition upon delivery
1. On transfer of goods, check each packaging unit for damage.
2. In the event of in-transit damage, assess the exact damage, document it and
notify KSB or the supplying dealer (as applicable) and the insurer about the
damage in writing immediately.
3.2 Transport
▪ Transport the device in its original packaging.
▪ Observe the transport instructions on the original packaging.
▪ Keep the original packaging for future transport and storage.
3.3 Storage
If the ambient conditions for storage are met, the function of the control unit is
safeguarded even after a prolonged period of storage.
CAUTION
Damage during storage by humidity, dirt or vermin
Corrosion/contamination of the control unit!
▷ For outdoor storage cover the (packed or unpacked) control unit and
accessories with water-proof material.
Table4: Ambient conditions for storage
Ambient condition Value
Relative humidity 85% max. (non-condensing)
Ambient temperature -10°C to + 70°C
▪ Store the control unit in dry, vibration-free conditions and, if possible, in its
original packaging.
▪ Store the control unit in a dry room where the level of atmospheric humidity is as
constant as possible.
▪ Prevent excessive fluctuations in atmospheric humidity (see table on ambient
conditions for storage).
3.4 Disposal
The product is classified as special waste due to several installed components:
1. Dismantle the product.
2. Separate and sort the materials
e.g. by:
- Aluminium
- Plastic cover (recyclable plastic)
3. Dispose of materials in accordance with local regulations or in another
controlled manner.
PCBs, power electronics, capacitors and electronic components are all special
waste.
The requirements pertaining to RoHs 2002/95/EC are fulfilled.
To Next Page
Loading...
