KSB BoosterControl Advanced - 8 Commissioning;Start-Up;Shutdown; Ambient Conditions for Commissioning and Operation; Commissioning; Starting up the System

8 Commissioning/Start-up/Shutdown
34 of 88
BoosterControl Advanced
8 Commissioning/Start-up/Shutdown
8.1 Ambient conditions for commissioning and operation
Table27: Ambient conditions for operation
Condition Value
Ambient temperature 0 ... 50 °C
Relative humidity 50 %
(non-condensing)
Installation altitude Max. 1,000m above MSL
(higher installation altitudes are subject to a
reduction factor)
8.2 Commissioning
A checklist can be used for commissioning. (ðSection12.1,Page81)
8.2.1 Starting up the system
See system documentation.
8.3 Setting BoosterControl Advanced
Note the general operating instructions. (ðSection6,Page21)
1. Select parameter 3-2-1-1.
2. Enter access level and associated password:
- Customer: 7353
Users logged in to BoosterControl Advanced are automatically logged off after 15
minutes of inactivity.
8.3.1 Setting the display language
1. Select parameter 3-1-1-1.
2. Select the language required and press "OK" to confirm.
8.3.2 Setting the time/date
BoosterControl Advanced does not automatically change between summer and
winter time.
1. To set the date, select parameter 3-7-1.
2. To set the time of day, select parameter 3-7-2.
8.4 Basic configurations of the pressure booster system
BoosterControl Advanced can be used for various operating modes of pressure
booster systems.
A set of preset parameters can be loaded for every operating mode.
The following operating modes are possible: