KSB BoosterControl Advanced - Page 60

10 Parameter list
60 of 88
BoosterControl Advanced
Parameter Description Factory setting Possible settings min. value max. value Read access right Write access right
3-2-2-7 Edit Pump Opera. hrs
Editing pump operating hours
- - - - Service Service
3-2-2-7.1.1 Pump number
Number of pump
1 1.. 6 1 6 Service Service
3-2-2-7.2.1 Hours
Hours
0 0.. 500000 0 500000 Service Service
3-2-2-7.2.2 Minutes
Minutes
0 0.. 59 0 59 Service Service
3-2-2-7.2.3 Seconds
Second
0 0.. 59 0 59 Service Service
3-2-2-8 Reset Sys. Oper. hrs
Resetting the operating hours
- OK,
Failed
- - Service Service
3-2-3 Factory Test
Factory test
- - - - Factory Nobody
3-2-3-1 Factory Test
Factory test
- - - - Factory Factory
3-2-3-1.1.1 Test result
Test result
Failed Failed,
Passed
- - Factory Factory
3-3 Configuration
System configuration
- - - - Everybody Nobody
3-3-1 Number of pumps
Maximum number of pumps used in
system
3 1.. 6 1 6 Everybody Service
3-3-2 Inlet
General configuration, suction side
Pressure switch Pressure switch,
pressure sensor,
water flow detection,
inlet tank/gate valve,
inlet tank/
proportional valve
- - Everybody Service
3-3-3 Discharge
General configuration, discharge side
Cascade Cascade (without
frequency inverter),
1 jockey,
2 jockeys,
floating frequency
inverter,
frequency inverter
per pump
- - Everybody Service
3-3-4 WSD
Configuring the water flow detection for the
tank
Off Off,
1 tank,
2 tanks,
3 tanks,
1 tank + temp.,
2 tanks + temp.,
3 tanks + temp.,
temperature
- - Everybody Service