KSB PumpDrive - Page 111

Parameter Description Factory
setting
Setting Unit Access level Possible settings
EP MP Min. Max.
3-1-6-7 Factory Passwd
Change password
for factory access
level
- - 0 9999 - Factory -
3-1-7 Too many BinF
Submenu for
displaying the
network
configuration
- - - - - - -
3-1-7-1 Network Manager
Activate/deactivate
operation as
network manager
2 2 - - - Customer Disabled
Enabled
3-1-7-2 Server Guard Tm
Server guard time
3.5 3.5 2 4 s Customer -
3-1-7-3 Backup Adv-HMI
Backup Advanced
HMI
1 1 - - - Customer Disabled
Enabled
3-1-7-4 Backup Guard Tm
Time value for
identifying
PumpDrive as the
active master
control panel
1 1 0.1 10 s Customer -
3-2 PumpDrive
PumpDrive menu
3-2-1 Basic Settings
Submenu for
displaying basic
settings
- - - - - - -
3-2-1-1 MultiPump Role
Selection of role in
multiple pump
configuration
1 2 - - - Customer Standard slave
Auxiliary main
pump
3-2-1-2 PumpDrive ID
PumpDrive ID
0 0 0 6 - Customer -
3-2-1-3 Local Bus ID
Display of local bus
ID
0 0 0 0 - Customer -
3-2-1-4 Curr Pump Role
Selection of role of
pump
1 1 - - - Customer Single pump
Standard Slave
Auxiliary Main
Pump
3-2-1-5 Fbus control
Activate/deactivate
field bus control
1 1 - - - Customer Disabled
Enabled
3-2-2 Units
Units
- - - - - - -
3-2-2-1 Setpoint Unit
Selection of setpoint
unit
1 1 - - - Customer Selection list III
(⇨ Section 10.1
Page 129)
3-2-2-2 Q Unit
Selection of flow
rate unit
29 29 - - - Customer Selection list III
(⇨ Section 10.1
Page 129)
3-2-2-3 Pressure Unit
Selection of pressure
unit
1 1 - - - Customer Selection list III
(⇨ Section 10.1
Page 129)
3-2-3 Set-up
Submenu for
displaying setup
- - - - - - -
10 Parameter lists
PumpDrive
111 of 162