KTM 1290 SUPER DUKE R 2021 - Service Work on the Chassis 13; Lifting the Motorcycle with the Rear Lifting Gear; Removing the Rear of Motorcycle from the Lifting Gear; Lifting the Motorcycle with the Front Lifting Gear

SERVICE WORK ON THE CHASSIS 13
99
13.1 Lifting the motorcycle with the rear lifting gear
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
E00695-01
– Place the adapter into the rear lifting gear.
Rear wheel work stand for single-sided swing arm
(61329955000)
– Position the motorcycle upright, place the lifting gear in the
axle, and raise the motorcycle.
13.2 Removing the rear of motorcycle from the lifting gear
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
402029-10
– Secure the motorcycle against falling over.
– Remove the rear wheel stand and lean the vehicle on side
stand
1
.
13.3 Lifting the motorcycle with the front lifting gear
Note
Danger of damage The parked vehicle can roll away or fall over.
– Park the vehicle on a firm and level surface.
Preparatory work
– Lift the motorcycle with the rear lifting gear. ( p. 99)
E00696-01
Main work
– Move the handlebar to the straight-ahead position. Align the
front lifting gear with the fork legs.
Front wheel work stand, small (61129965000)
Info
Always raise the motorcycle at the rear first.
– Lift the motorcycle at the front.