17 COOLING SYSTEM
144
17.1 Checking the coolant level in the compensating tank
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not open the radiator, the radiator hoses or other cooling system components if the engine or the
cooling system are at operating temperature.
– Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses
or other components of the cooling system.
– In the event of scalding, rinse the area affected immediately with lukewarm water.
Warning
Danger of poisoning Coolant is toxic and a health hazard.
– Keep coolant out of the reach of children.
– Do not allow coolant to come into contact with the skin, the eyes and clothing.
– Consult a doctor immediately if coolant is swallowed.
– Rinse the affected area immediately with plenty of water in the event of contact with the skin.
– Rinse eyes thoroughly with water and consult a doctor immediately if coolant gets into the eyes.
– Change clothing if coolant spills onto your clothing.
Condition
The engine is cold.
The radiator is completely full.
S03955-10
– Park the motorcycle on a horizontal surface.
–
Check the coolant level in the compensating tank
1
.
The coolant level must be between MIN and MAX.
» If there is no coolant in the compensating tank:
– Check the cooling system for leaks.
Info
Do not start up the motorcycle!
– Add the coolant/bleed the cooling system.
» If the coolant in the compensating tank is not at the
required level, but the tank is not empty:
– Correct the coolant level in the compensating tank.
( p. 144)
17.2 Correcting the coolant level in the compensating tank
Warning
Danger of scalding During motorcycle operation, the coolant gets very hot and is under pressure.
– Do not open the radiator, the radiator hoses or other cooling system components if the engine or the
cooling system are at operating temperature.
– Allow the cooling system and the engine to cool down before you open the radiator, the radiator hoses
or other components of the cooling system.
– In the event of scalding, rinse the area affected immediately with lukewarm water.
To Next Page
Loading...
