KTM 1290 SUPER DUKE R 2021 User Manual

WHEELS, TIRES 15
123
S04802-10
–
Loosen screw
2
and screws
3
.
–
Using your hand, press on screw
2
to push the wheel
spindle out of the axle clamp. Remove screw
2
.
Warning
Danger of accidents Damaged brake discs reduce
the braking effect.
– Always lay the wheel down in such a way that
the brake discs are not damaged.
– Hold front wheel and remove wheel spindle. Take the front
wheel out of the fork.
S03928-10
–
Remove spacers
4
.
15.2 Installing the front wheel
S03928-11
(SUPER DUKE R)
– Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
– Change front wheel bearing.
–
Clean and grease shaft seal rings
1
and contact sur-
faces
A
of the spacers.
Long-life grease ( p. 177)
S03929-10
–
Insert wide spacer
2
on the left in the direction of travel.
Info
Arrow
B
indicates the direction of travel of the
front wheel.
The wheel speed sensor wheel is on the left viewed
in the direction of travel.
– Insert the narrow spacer on the right in the direction of
travel.

KTM 1290 SUPER DUKE R 2021 Specifications

General

Displacement	1301 cc
Transmission	6-speed
Rear Suspension	WP APEX monoshock, fully adjustable
Seat Height	835 mm
Fuel Tank Capacity	16 liters
Dry Weight	189 kg
Bore x Stroke	108 mm x 71 mm
Compression Ratio	13.5:1
Fuel System	Electronic fuel injection
Lubrication	Forced oil lubrication with 3 oil pumps
Wheelbase	1482 mm
Traction Control	MTC (Motorcycle Traction Control), lean-angle sensitive
Engine Type	V-Twin, 4-stroke
Power	180 hp
Torque	140 Nm @ 8000 rpm
Frame	Chromium-Molybdenum steel frame, powder coated
Front Suspension	WP APEX 48
Front Brake	320 mm discs
Rear Brake	Brembo two-piston caliper, 240 mm disc
Clutch	PASC slipper clutch, hydraulically actuated
ABS	Bosch 9.1 MP (incl. Cornering ABS and Supermoto mode)