19 STORAGE 108
19.1 Storage
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
– Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that has been contaminated with
fuel. Store fuel properly in a suitable canister and keep away from children.
Info
If you plan to garage the motorcycle for a longer period, perform the following steps or have them performed.
Before storing the motorcycle, check all parts for function and wear. If service, repairs, or replacements are necessary, you
should do this during the storage period (less workshop overload). In this way, you can avoid long workshop waiting times at
the start of the new season.
401058-01
– When refueling for the last time before taking the motorcycle out of service, add
fuel additive.
Fuel additive ( p. 136)
– Refuel. ( p. 26)
– Clean the motorcycle. ( p. 107)
– Change the gear oil. ( p. 104)
– Check the antifreeze and coolant level. ( p. 93)
– Empty the carburetor float chamber. ( p. 103)
– Check the tire air pressure. ( p. 87)
(All XC models)
– Remove the battery. ( p. 89)
(All XC models)
– Recharge the battery. ( p. 90)
Guideline
Storage temperature of battery with-
out direct sunshine
0… 35 °C (32… 95 °F)
– Store the vehicle in a dry location that is not subject to large fluctuations in tem-
perature.
Info
KTM recommends jacking up the motorcycle.
– Raise the motorcycle with a lift stand. ( p. 44)
– Cover the vehicle with a tarp or similar cover that is permeable to air.
Info
Do not use non-porous materials since they prevent humidity from escaping,
thus causing corrosion.
Avoid running the engine for a short time only. Because the engine will not
warm up sufficiently, the water vapor produced during combustion will con-
dense, causing engine parts and the exhaust system to rust.
19.2 Preparing for use after storage
401059-01
(All XC models)
– Install the battery. ( p. 89)
– Remove the motorcycle from the lift stand. ( p. 44)
– Perform checks and maintenance work when preparing the vehicle for use.
( p. 23)
– Make a test ride.
To Next Page
Loading...
