11 SERVICE WORK ON THE CHASSIS 66
M01185-11
–
Mount and tighten screws
with the collar bushings.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
– Connect the fuel hose.
Finishing work
– Mount the seat. ( p. 56)
11.34 Checking the chain for dirt
400678-01
– Check the chain for heavy soiling.
» If the chain is very dirty:
– Clean the chain. ( p. 66)
11.35 Cleaning the chain
Warning
Danger of accidents Oil or grease on the tires reduces their grip.
– Remove oil and grease with a suitable cleaning material.
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
– Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Environmental hazard Hazardous substances cause environmental damage.
– Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
The service life of the chain depends largely on its maintenance.
Preparatory work
– Raise the motorcycle with a lift stand. ( p. 44)
400725-01
Main work
– Clean the chain regularly and then treat with chain spray.
Chain cleaner ( p. 136)
Off-road chain spray ( p. 136)
Finishing work
– Remove the motorcycle from the lift stand. ( p. 44)
To Next Page
Loading...
