EasyManua.ls Logo

KTM 150 SX - 11.34-11.38 Chain and Sprocket Maintenance

KTM 150 SX
145 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11 SERVICE WORK ON THE CHASSIS 65
Warning
Danger of poisoningFuel is poisonous and a health hazard.
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Main work
Check the routing of the throttle cable. ( p. 71)
M01182-02
(All 125/150 models)
Position the fuel tank and fit the two spoilers to the sides of the radiator
bracket.
Make sure that no cables are trapped or damaged.
M01164-11
Mount the fuel tank breather.
Mount and tighten screw
with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
M01163-11
Mount and tighten screws
.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)
Connect the fuel hose.
M01186-02
(All 250/300 models)
Position the fuel tank and fit the two spoilers to the sides of the radiator
bracket.
Make sure that no cables are trapped or damaged.
L00951-10
Mount the fuel tank breather.
Mount and tighten screw
with the rubber bushing.
Guideline
Remaining screws, chassis M6 10 Nm
(7.4 lbf ft)

Table of Contents

Related product manuals