EasyManua.ls Logo

KTM 150 SX - Adding Rear Brake Fluid

KTM 150 SX
145 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
12 BRAKE SYSTEM 81
12.11 Adding rear brake fluid
Warning
Danger of accidentsBrake system failure.
If the brake fluid level drops below the specified marking or the specified value, this is an indication that the brake system
is leaking or that the brake linings are completely worn down. Check the brake system and do not continue riding. (Your
authorized KTM workshop will be glad to help.)
Warning
Skin irritationBrake fluid can cause skin irritation on contact.
Avoid contact with skin and eyes, and keep out of the reach of children.
Wear suitable protective clothing and goggles.
If brake fluid comes into contact with the eyes, flush the eyes thoroughly with water and consult a physician immediately.
Warning
Danger of accidentsReduced braking efficiency due to old brake fluid.
Change the brake fluid of the front and rear brake according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazardHazardous substances cause environmental damage.
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never use DOT 5 brake fluid! It is silicone-based and purple in color. Oil seals and brake lines are not designed for DOT 5
brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container.
Preparatory work
Check the rear brake linings. ( p. 82)
M01179-10
Main work
(All 125/150 models)
Stand the vehicle upright.
Remove screw cap
with membrane
and the O-ring.
Add brake fluid to level
.
Brake fluid DOT 4 / DOT 5.1 ( p. 134)
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilled brake fluid immediately with water.
101704-10
(All 250/300 models)
Stand the vehicle upright.
Remove screw cap
with membrane
and the O-ring.
Add brake fluid to level
.
Brake fluid DOT 4 / DOT 5.1 ( p. 134)
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilled brake fluid immediately with water.

Table of Contents

Related product manuals