MAINTENANCE ON CHASSIS AND ENGINE 71
400348-11
– The cross over setting is measured between the sliding bushing and the collar of
the spring retainer .
Guideline
Cross over 14±1.5 mm (0.55±0.059 in)
– Change the settings accordingly and lock the adjusting ring.
Info
The sliding bushing is made of plastic. Therefore, do not lock it too tightly to
avoid damaging the thread.
The left and right shock absorbers should have the same settings.
– Remove the vehicle from the work stand. ( p. 66)
9.7Front shock absorber - adjusting the spring preload
Danger
Danger of accidents The shock absorber is under high pressure.
– The shock absorber is filled with highly compressed nitrogen, so never dismantle the shock absorber or carry out any mainte-
nance on it yourself.
Warning
Danger of accidents Do not make any radical changes to the adjustment of the shock absorbers.
– Make adjustments in small steps only.
Info
Increasing the spring preload raises the center of gravity of the vehicle. This can have a large impact on vehicle handling.
To Next Page
Loading...
