MAINTENANCE ON CHASSIS AND ENGINE 80
9.12Installing the rear shock absorber x
100079-10
– Check parts for damage and wear. Replace damaged or worn parts.
– Position the shock absorber in the vehicle with the reservoir on the right. Mount and
tighten the top screw .
Guideline
Screw, rear top shock absorber M12 60 Nm
(44.3 lbf ft)
– Position the shock absorber in the swingarm. Mount and tighten the bottom screw.
Guideline
Screw, rear bottom shock absorber M12 70 Nm
(51.6 lbf ft)
– Remove the tension belt.
– Install the rear fender. ( p. 142)
– Remove the vehicle from the work stand. ( p. 66)
9.13Checking the toe x
– Park the vehicle on a horizontal surface.
– Check the tire condition. ( p. 125)
– Checking the tire air pressure. ( p. 126)
– Check the chassis parts for damage, play and wear.
To Next Page
Loading...
