MAINTENANCE ON CHASSIS AND ENGINE 77
Info
Increasing the spring preload raises the center of gravity of the vehicle. This can have a large impact on vehicle handling.
Tip
Before changing the spring preload, make a note of the present setting, e.g., by measuring the length of the spring.
–
Remove the rear shock absorber. x ( p. 78)
– After removing the shock absorber, clean it thoroughly.
100082-10
– Loosen the lock nut . Hold adjusting ring while doing so. Suitable tools are
available from an authorized KTM workshop.
Hook wrench (83019002000)
Info
Do not loosen lock nut at the top of the shock absorber.
– Turn adjusting ring until the spring is no longer under tension.
To Next Page
Loading...
