MAINTENANCE ON CHASSIS AND ENGINE 86
600128-10
– Loosen nuts .
600126-10
– Remove screws with bushings .
– Check parts for damage and wear. Replace damaged or worn parts.
600127-10
– Insert the tool in the heim joint and clip onto the A-arm.
Camber gauge (83019014000)
– Check the camber on both heim joints.
» If the marking is not aligned with the top edge of the A-arm:
– Turn the tool with the heim joint in steps of 180° until the marking is in line
with the top edge of the A-arm.
– Remove the tool .
To Next Page