MAINTENANCE ON CHASSIS AND ENGINE 90
100104-10
Setting a wide toe width:
– Mount the spacing sleeve with the cone facing inward.
– Mount the conical ring with the cone facing outward.
– Mount the wheel hub .
– Mount the washer and the new self-locking nut.
100102-10
– Remove the vehicle from the work stand. ( p. 66)
– Tighten nuts on both sides.
Guideline
Nut, rear wheel hub M18x1.5 130 Nm
(95.9 lbf ft)
– Shift gear to neutral.
To Next Page
Loading...
