KTM 690 Enduro R EU 2013 - 8 Frame; Removing the Engine Guard; Installing the Engine Guard

8 FRAME 36
8.1 Removing the engine guard
202021-10
– Remove screws 1 on the left and right.
– Pull the engine guard forward out of the holders and set it down.
8.2 Installing the engine guard
202021-11
– Slide the engine guard into holders 1 at the rear.
– Position the engine guard. Mount and tighten screws 2.
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)