2 SETUP
6
S04681-10
– Charge the 12-V battery. ( p. 10)
– Install the 12-V battery.
–
Plug in connector
5
on the starter relay.
S03406-10
–
Remove the rear fairing. ( p. 13)
– Take off the side cover. ( p. 13)
– Remove the rear left side cover. ( p. 14)
– Remove the rear right side cover. ( p. 14)
Info
A total of four markings
6
have been added to the
underside of the rear fairing and the two side covers.
– Drill the holes for the grab handle in three steps at these
points.
Guideline
Bore diameter for the grab
handle
14.5 mm (0.571 in)
– Install the rear left side cover. ( p. 15)
– Install the rear right side cover. ( p. 15)
– Fit the rear fairing. ( p. 16)
S03411-10
–
Store tool set
7
in the tool set compartment.
– Mount side cover. ( p. 16)
S03407-01
– Mount the reflector.
To Next Page
Loading...
