Installation, Connection, Exchange
20 of 26
Ro/Me/03/23 03.99.02 en
(6) Put robot into operation and move it into a suitable position to install end--effector and
additional equipment.
Turn main switch on the robot control cabinet to “OFF” and secure it with a pad-
lock to prevent unauthorized persons from switching it on again.
(7) Install end--effector and additional equipment.
If any additional equipment (working range monitoring devices, etc.) is installed
on the robot, the instructions and warnings in the relevant Doc. Modules must
be strictly observed.
(8) Connect all other cables which have been removed.
(9) Put robot into operation.
To Next Page
Loading...
