Master Mode
Reset
11-17
CLOCK
Pressing the CLOCK soft button allows you to view the PC3A’s System Clock (see below.) When
objects are saved, they are time stamped with the date and time of this clock. This time stamp can
be seen in the le properties when viewing the les with a computer.
The Format soft button changes the view format of the date on this page. The Set soft button
brings you to the Set clock page where you can set the system clock and date. Use the cursor to
move between elds, use the alpha wheel or plus/minus buttons to change each eld. On the Set
page, press the Set soft button to save changes and return to the System Clock page, or the
Cancel soft button to return to the System Clock page without saving changes.
The Chrono soft button brings up the PC3A’s Chronometer (stop-watch) page (see below.) This
can be useful for timing the length of songs or performances. Press the Start soft button to begin
timing. The Chronometer will continue running even if you exit to other screens or modes. Press
the Stop soft button to stop timing, the Reset soft button to reset the Chronometer, or the Cancel
soft button to return to the System Clock page.
Reset
Press the Reset soft button if you want to return your PC3A’s memory to the state it was in when
you bought it.
CAUTION: Resetting the PC3A system causes ALL parameters to be restored to default values and ALL
user objects to be erased. The PC3A will ask you if you want to delete everything (meaning all RAM
objects), and a pair of Yes/No soft buttons will appear. Press No if you want to keep any objects you have
saved. Press Yes, and everything stored in RAM will be erased. After a few seconds, the PC3A will return
to the Program mode page.
To Next Page
Loading...
Need help?
General
