6-30
Program Mode
The DSP Modulation (DSPMOD) Page
The label of a function-parameter depends on its corresponding function-block in the current
layer’s algorithm. The above DSPCTL page corresponds to the following algorithm:
The DSP Modulation (DSPMOD) Page
Before reading further, be sure to read Algorithm Basics on page 6-23 and Common DSP Control
Parameters on page 6-24.
Press the DSPMOD soft button to call up the DSP Modulation (DSPMOD) page, which is
displayed below:
Parameter Range of Values Default
Source 1 Control Source List Off
Depth (Depends on Function) 0
Source 2 Control Source List Off
Depth Control Control Source List Off
Minimum Depth (Depends on Function) 0
Maximum Depth (Depends on Function) 0
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted in
Common DSP Control Parameters, any adjustments made to the function-parameters on the
DSPMOD page are reected in the corresponding function-parameters on the DSPCTL page. The
To Next Page
Loading...
