Kurzweil PC3A - The DSP Control (DSPCTL) Page

Program Mode
The DSP Control (DSPCTL) Page
6-29
The DSP Control (DSPCTL) Page
Before reading further, be sure to read Algorithm Basics on page 6-23 and Common DSP Control
Parameters on page 6-24.
Press the DSPCTL soft button to call up the DSP Control (DSPCTL) page, which is displayed
below:
Function Parameter Range of Values Default
Pitch
Pitch -128 to 127 semitones 0
Fine Adjust ± 100 cents 0
Hertz Adjust ± 10.00 Hertz 0
Key Tracking ± 2400 cents/key 0
Velocity Tracking ± 7200 cents 0
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
(Function) (Function-Parameter) (Depends on Function) (Depends on Function)
Level
Level -96 to 24 decibels -6
Key Tracking ± 2.00 decibels/key 0
Velocity Tracking ± 96 decibels 35
Each eld in the left-hand column of the page is a function-parameter of the current layer’s
algorithm. You can coarsely adjust the function-parameter in these left-hand elds—as noted in
Common DSP Control Parameters, any adjustments made to the function-parameters on the
DSPCTL page are reected in the corresponding function-parameters on the DSPMOD page. The
right-hand side of the DSPCTL page is the subpage of the highlighted function-parameter—on
the subpage are the ne adjust parameters and hard-wired parameters. To access the parameters
on the subpage, highlight the function-parameter you wish to edit, and then press the > button to
move the cursor into the subpage.