12-26
Song Mode and the Song Editor
Song Editor: Track Functions
Insert
The Insert function is used to add blank time to the current song, modifying the song’s End point
appropriately. The Insert function will aect all tracks. This is similar to splicing a piece of blank
tape to an existing segment of recording tape.
Location: Bars : Beats : Ticks
The insertion point for the blank time being added is selected as a Bar and Beat Location value.
Events that occurred at or after this Bar and Beat, before you insert time, are not erased when you
perform this function, rather they are oset by the length of the blank time being added to a Bar
and Beat later in the song.
Amount: Bars : Beats : Ticks
The length of the blank time being added is dened as a number of Bars and Beats in the Amount
parameter.
There are no Region/Criteria parameters available for the Insert function.
Delete
The Delete function is used to remove a region of time from the current song. This function is
dierent from the erase function because not only does it remove the events from the selected
time, it will delete the entire selected range of time from the song, modifying the song’s End point
appropriately (on all tracks). This is similar to cutting a section out of a tape and splicing the
ends.
To Next Page
Loading...
Need help?
General
