29
Follow these steps to set or verify the dish type or
configuration of each SWM receiver and/or DVR
connected to the TracVision system.
NOTE: Refer to your selected receiver/DVR manual
for specific configuration instructions.
a. Press the Menu button on the receiver’s/
DVR’s remote control to display its menu on
the connected television.
b. Navigate to the Satellite screen (Settings >
Settings & Help > Satellite) and select Repeat
Satellite Setup.
c. At the Satellite Dish Setup menu, set the Dish
Type and RB/INTL to the settings below.
Switch Type should auto-populate:
Dish Type: SL3 LNB.
RD/INTL: None Selected
Switch Type: SWM Module 15 CH
d. Make any necessary changes, then choose
Continue to complete setup (see Figure 48).
e. Repeat this procedure for each connected
receiver and DVR.
Figure 48: DIRECTV SWM Receiver/DVR Configuration
Configure SWM Receivers/DVRs
20
To Next Page
Loading...
Need help?
General
