FUEL TANK REMOVAL
Remove the floor board. (
2-4)
Remove the leg shield . (
2-5)
Disconnect the fuel unit wire connector.
Remove the fuel tube between the fuel tank
and the fuel filler.
Disconnect the fuel vapor tube.
Remove the fuel tank.
The installation sequence is the reverse of
removal.
FUEL STRAINER REMOVAL
Remove the fuel strainer from the fuel tank.
INSPECTION
Inspect if the fuel strainer is clogged and clean
it with compressed air.
INSTALLATION
Install the fuel strainer with its arrow mark
toward the fuel pump.
• When removing the fuel strainer, do not
allow flames or sparks near the
working area and drain the residual
gasoline into a container.
To Next Page