KYMCO DINK50 - Spark Plug; Ignition Coil Inspection

17. IGNITION SYSTEM
17-3
SPARK PLUG
For spark plug inspection and adjustment,
refer to page
(
3-5).
IGNITION COIL INSPECTION
Remove the seat and met-in box. (

2-3)
Remove the ignition coil
IGNITION COIL PERFORMANCE TEST
Test the ignition coil using a CDI tester.
When there is no spark at the spark plug,
replace the ignition coil with a new one.
IGNITION COIL CONTINUITY TEST
Inspect the continuity of the ignition coil,
primary coil and secondary coil.
Measure the ignition coil resistances at
20℃ .
Primary coil
0.153_ 0.187Ω
Secondary coil
without plug cap
3.24_ 3.96KΩ
Secondary coil with
plug cap
6.99_ 10.21KΩ
Ignition Coil
AC 110V
Correctly operate the CDI tester following
the manufacturer‘s instructions.
＊
This is a general test. Accurate ignition
coil test must be performed with a CDI
tester.
＊
Ignition Coil
Ignition Coil
Secondary Coil
Primary Coil
Ignition Coil
Spark Plug
CDI Tester
Special Coupler (KB7)
CDI Unit
www.PlanDeGraissage.org