KYMCO DINK50 - Cylinder Head

6. CYLINDER HEAD/CYLINDER/PISTON
6-4
CYLINDER HEAD
REMOVAL 〈 SH10AA〉
Remove the rear carrier.
Remove the frame body cover. (

2-5)
Drain the coolant.
Disconnect the thermosensor wire from the
thermosensor.
Disconnect the water hose from the
thermostat housing.
Remove the spark plug cap.
Remove the two joint lock nuts on the front
of the exhaust muffler and then remove the
two exhaust muffler lock bolts.
The installation sequence is the reverse of
removal.
Remove the spark plug.
Remove the cylinder head bolts and the
cylinder head.
Remove the cylinder head gasket.
Loosen the bolts diagonally in 2 or 3
times.
＊
Cylinder head Bolts
Exhaust muffler joint lock nut
Bolts
When installing the exhaust muffler,
first tighten the two nuts on the front
and then tighten the two bolts.
＊
Cylinder Head
Spark Plug
Spark Plug Cap
www.PlanDeGraissage.org