7.3 Overload protection - motor protection
The overload protection switches the drive off if the motor becomes overloaded
by trying to climb over too high an obstacle such as a kerbstone, or if you try to
climb too steep of an incline.
If the motor is overloaded, the following happens:
• the
scooter becomes noticeably slower and then stops
• the control system switches the
scooter off
To rectify this:
Switch the scooter off and allow it to cool down for a few minutes.
Switch the scooter on again and
•Reverse away from the obstacle (such as kerbstone) and then try again at
a lower point.
•Be careful turning the scooter around on inclines, and always reverse
away very slowly.
Tipping hazard!
There is an increased tipping hazard if the incline is very steep.
• T
ry
to get
help
from
a
second
person
when turning your
scooter around.
Accident hazard in push mode!
If the incline is too steep, there is a danger that you will not be able
to hold into the scooter and that it will roll down the incline
uncontrolled.
• T
ry
to get
help
from
a
second
person when turning your scooter
around.
To Next Page
Loading...
Need help?
General
