9.0 Pushing
In order to be able to push the
scooter you must disengage
the drive motor.
The disengaging lever (1) is
located on the right-hand side
of the scooter
No one is permitted to sit on
the scooter
When it is being pushed.
= Pushing (a):
Switch off.
Push the
disengaging
lever (1)
forwards as far as the stop
(limit position).
=Driving (b):
Pull the disengaging lever (1)
to the rear as far as the stop
(limit position).
Disengaging the drive
NOTES
• Always switch off to push it.
• If a pre-set speed is exceeded while you are pushing ,
the drive motor will switch on automatically and brake the scooter.
Risk of accidents!
• Do not pull the
disengaging
lever while driving.
• Never switch to push mode when somebody is sitting on the
scooter.
• The
engaging
lever always needs to engage securely at the limit
position.
• Do not
disengage
the motor when on an incline.
10.0 Attaching the shopping basket
Push the shopping basket(1)from
above into the basket holder
receptacles (2) on
the
tiller.
NOTE
Use the shopping basket only
for s
mall
loading.
To Next Page
Loading...
Need help?
General
