12
.
0
Things
to
know
12.1 The battery charger - functioning principle
The battery charger regulates the voltage (Volt) and
the current (Ampere) from your mains connection
down to the voltage required for charging your
batteries (24 Volt). The amount of charging current
required is dependent on the charging state of the
discharged batteries.
Batteries mostly discharged = more charging current
Batteries half discharged = decreased charging current
Batteries completely charged = no charging current
Since no charging current is flowing when the batteries are full, the
batteries cannot be overloaded.
12.2 The Batteries
The entire power supply is
taken over by two cycle-
proof 12 V gel batteries.
The scooter can either be fitted
with 22 Ah(Amp-hour) batteries
Only enclosed maintenance-free
deep cycle batteries are used.
The batteries located in
the removable battery
case beneath the seat.
The 22 Ah batteries are located
in one battery case
The battery case fitted with 22 Ah
batteries is fitted with its own charging
socket. This means that it is possible
to charge the batteries when
separated from the scooter (Chapter
11.1.2).
22 Ah x 2
To Next Page
Loading...
Need help?
General
