17
The headlight and the taillight can be turned on
only when the is
.(MX'er 150/125)
main switch in the " "
position
．
The headlight and the taillight can be turned on
only when the engine is starting.(MX'er 50)
NOTE:
NOTE:
Light switch
Turn the switch to the " " position to switch on
the low beam and the taillight.
Turn the switch to the " " position to switch on
the high beam and the taillight.
Turn the switch to the " " position to switch on
the position light.
Hazard switch (Only MX'er 150/125)
" "At this position, the front and rear right and
left turn signal lights wink together.
" "At this position, the front and rear right and
left turn signal lights go out together.
●
CAUTION:
Turn on this switch when parking or there is
a special condition.
After the hazard switckh is turned on, it will
not reset automatically. Be sure to reset it
after rse to avoid affecting the traffic saffic
safety,
When the signal lights are winking , the
hazard switch does not work.
．
．
．
To Next Page
Loading...
