KYMCO MXU 300 - Page 109

6. ENGINE REMOVAL/INSTALLATION
6-11
MXU 300/250
Slide the rubber sleeve back to expose the
starter motor wire nut.
Remove the starter motor wire nut for
disconnect the starter motor wire.
Loosen the inlet hose band screw and then
disconnect the inlet hose from the left
crankcase cover.
Loosen the outlet hose band screw and then
disconnect the outlet hose from the left
crankcase cover.
Remove the front mounting bolt and nut.
Inlet Hose Outlet Hose
Screw Screw
Nu
t
Bol
t
Rubber Sleeve Nu
t