15. REAR WHEEL/AXLE/SUSPENSION/
DRIVING MECHANISM
15-42
MXU 300/250
Set the drive shaft assembly into the
swingarm, then secure drive shaft and
spring onto the pinion gear shaft in the final
gear case.
Pack 3 g (0.1 oz) of grease into each bearing
cavity.
Apply grease to the new dust seal lips and
install them into the swingarm pivot until
they are flush.
Apply molybdenum disulfide grease to the
universal joint splines and the secondary
driven bevel gear shaft splines.
Set the swingarm into the frame and engage
the universal joint onto the secondary driven
bevel gear shaft.
Drive Shaft/Spring
Apply Grease
Apply Gearse
Apply Gearse
To Next Page
