5-21
Operation on the Machine > Sending Document via E-mail
Sending Document via E-mail
When transmitting using wireless LAN, select the interface dedicated to the send function in advance.
Primary Network (Client) (page 8-37)
Configuring Settings before Sending
Before sending an E-mail, configure the SMTP and E-mail settings using the Command Center RX.
E-mail Settings (page 2-58)
Sending Scanned Document via E-mail
1
[Home] key > [Send]
2
Place the originals.
3
In the basic screen for sending, select [E-mail].
4
Enter destination E-mail address > [OK]
Up to 128 characters can be entered.
To enter multiple destinations, select [Next Destination] and enter the next destination. Up to
100 E-mail addresses can be specified.
You can register the entered E-mail address in the Address Book by selecting [
Menu
] > [
Add to
Address Book
]. You can also replace the information for a previously registered destination.
Destinations can be changed later.
5
Select the color mode setting.
Loading Originals (page 5-2)
Character Entry Method (page 11-8)
Confirmation Screen of Destinations (page 5-43)
Color Selection (page 6-16)
To Next Page
Loading...
