3-21
Preparation before Use > Registering Destinations in the Address Book
Registering a Group
Compile two or more contacts into a group. Designations in the group can be added at the same time. When adding a
group, a maximum of 50 groups can be added in the Address Book.
1
Display the screen.
[System Menu/Counter] key > [Address Book/One Touch] > [Address Book] > [] >
[Group]
2
Add the name.
Enter the
group
name to be displayed on the Address Book > [Next]
3
Select the members (destinations).
1 Select [Member].
2 Select
[].
3 Select destinations (contacts) to add to the group. The selected destinations are indicated
by a checkmark in the check box.
4 Select [OK].
If you have more destinations to add, repeat Steps 2 to 4.
5 Select [End].
6 To specify the Address Number, select [Address Number].
7 Use [+] / [-] or the numeric keys to enter an address number (001 to 250).
To have the number assigned automatically, enter "000".
8 Select [OK].
4
Check if the selected destination was added to the group >
[Save]
The group is added to the Address Book.
To add a group, you need individually added destinations. Register one or more individual destinations as needed
before proceeding. Up to 100 individually registered destinations and a combined total of up to 5 SMB and FTP
destination folders can be registered in a single group.
Up to 32 characters can be entered.
Refer to the following for details on entering characters.
Character Entry Method (page 11-8)
Destinations can be sorted or searched by destination name or address number.
Specifying Destination (page 5-38)
• Address Number is an ID for a destination. A free number can be selected.
• If you specify an address number that is already in use, an error message appears.
To Next Page
Loading...
