5-39
Operation on the Machine > Using a Custom Box
Using a Custom Box
Custom Box is a component box which you can create within the Document Box and store data for later retrieval. You
can create or delete a Custom Box, and manipulate data in various ways as described below:
Creating a New Custom Box
1
Display the screen.
1 Select [Custom Box] on the Home screen.
2 [Menu] > [Add]
2
Create the Custom Box.
1 Enter the box name > [Next]
Up to 32 characters can be entered.
2 Check the settings and change or add information as needed.
Creating a New Custom Box (page 5-39)
Saving Scanned Documents to a Custom Box (page 5-42)
Moving Documents in Custom Box (page 5-43)
Copying Documents in Custom Box into Other Boxes (page 5-43)
Copying Documents in Custom Box to USB Drive (page 5-44)
Joining Documents in Custom Box (page 5-45)
Deleting Documents in Custom Box (page 5-46)
Printing Documents in Custom Box (page 5-46)
Sending Documents in a Custom Box (page 5-47)
Sending Documents in Custom Box to E-mail Address of Logged in user. (page 5-48)
Scanning Document Stored in a Custom Box (page 5-49)
The operation on Custom Box you perform from operation panel can also be made using Command Center RX.
Command Center RX User Guide
• To use Custom Box, an optional hard disk/SSD must be installed in the machine.
• If user login administration is enabled, you can only change the settings by logging in with administrator privileges.
The factory default login user name and login password are set as shown below.
Login User Name: 6000
Login Password: 6000
• If user login administration is enabled, log in with administrator privileges to perform the following operations. They
cannot be performed with user privileges.
- Creating a box
- Deleting a box of which owner is another user.
Character Entry Method (page 11-10)
To Next Page
Loading...
Need help?
General