8-53
Setup and Registration (System Menu) > System Menu
Auto Color Correction This setting allows you to adjust the detection level used by the machine to determine whether
the original is color or black and white during Auto Color Mode. Setting a lower value will result
in more originals being identified as color, while a larger value will tend to increase the number
of originals being identified as black and white.
Value: 1 (Color), 2, 3, 4, 5 (B & W)
Correcting Black Line Correct fine lines (streaks caused by contamination), which may appear on the image, when
the document processor is used.
Value: Off, On
Display Brightness Set the brightness of the touch panel.
Value: 1 (Darker), 2, 3, 4, 5 (Lighter)
Drum Refresh 1 Remove image blur from the printout. It takes about 80 seconds. The time required may vary
depending on the operating environment.
Drum Refresh 1 (page 10-30)
Drum Refresh 1 cannot be performed while printing. Execute Drum Refresh 1 after the printing
is done.
Drum Refresh 2 Remove white dots from the printout. It takes about 80 seconds. To use [Drum Refresh 2], load
A4 or Letter size paper into the Multipurpose tray.
When you run [Drum Refresh 2], the machine sometimes makes a vibrating sound for about 80
seconds until drum refreshing is completed. The toner soiling on the ejected paper is normal
and does not indicate a fault.
Drum Refresh 2 (page 10-30)
Drum Refresh 2 cannot be performed while printing. Execute Drum Refresh 2 after the printing
is done.
Auto Drum Refresh This machine automatically performs Auto Drum Refresh to keep the best image quality by
monitoring its peripheral temperature and humidity. Auto Drum Refresh is performed when the
machine is powered on or recovered from Energy Saver mode.
Although you can select the time to perform Auto Drum Refresh, normally set it to [Normal]. If
[Off] or [Short] is selected, the best image quality may not be kept.
Value
Off: The Auto Drum Refresh will not be performed.
Short: Perform Auto Drum Refresh as Short.
Normal: Perform Auto Drum Refresh as Standard.
Long: Perform Auto Drum Refresh as Long.
Service Setting Settings for machine maintenance and inspection. This menu is primarily used by service
technicians to perform maintenance.
Item Description
To Next Page
Loading...
Need help?
General