10-14
Troubleshooting > Troubleshooting
Printouts are curled. Is the paper damp? Replace the paper with new paper. page 3-2
Cannot print. Is the machine plugged in? Plug the power cord into an AC outlet. ―
Is the machine powered on? Turn on the power switch. page 2-10
Are the USB cable and network cable
connected?
Connect the correct USB cable and
network cable securely.
page 2-8
Is the print job paused? Resume printing. page 7-13
Cannot print with USB
memory.
USB memory not
recognized.
Is the USB host blocked? Select [
Unblock
] in the USB host
settings.
page 8-32
― Check that the USB memory is securely
plugged into the machine.
―
Printouts have vertical lines. Is the slit glass dirty? Clean the slit glass. page 10-2
Dirt on the top edge or back
of the paper.
Is the interior of the machine dirty? Clean the interior of the machine. page 10-3
Part of the image is
periodically faint or shows
white lines.
― Open and then close the rear cover. page 2-3
― Select the [
System Menu/Counter
] key
> [
Adjust/Maint.
] > [
Service Setting
] >
[
MC
] and decrease the adjustment
value. Decrease the adjustment value 1
level at a time from the current value. If
there is no improvement after the value
is decreased by 1 level, decrease by 1
level again. If there is still no
improvement, return the setting to the
original value.
―
― Select the [
System Menu/Counter
] key
> [
Adjust/Maint.
] > [
Service Setting
] >
[
Drum Refresh
] > [
Yes
]
―
Print on the back of the
sheet is visible on the front.
― Set [
Prevent Bleed-through
] to [
On
]. page 6-18
page 8-13
Symptom Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
