10-24
Troubleshooting > Troubleshooting
T
Send Error.
*1
— An error has occurred during
transmission. The job is canceled.
Select [End].
Refer to Responding to Send Error
for the error code and corrective
actions.
page 10-26
System error. — System error has occurred. Follow
the instructions on the screen.
—
*1 When Auto Error Clear is set to [On], processing resumes automatically after a set amount of time elapses. For details
on Auto Error Clear, refer to the following:
Auto Error Clear
(page 8-40)
Message Checkpoints Corrective Actions
Reference
Page
The cover is open. Is there any cover which is open? Close the cover indicated on the
screen.
—
Are the toner containers installed
correctly? Is a toner container out
of place?
Make sure all four colors of toner
containers are installed correctly,
and close the right cover.
page 10-5
The device cannot be
connected because
allowed connections
would be exceeded.
— Cancel a connection to a portable
device that is not being used, or set
the machine's auto disconnect time
to break portable device
connections.
—
The manufacturer
assumes no
responsibility for
damage caused by a
non-genuine toner.
Is the installed toner container our
own brand?
We will not be liable for any damage
caused by the use of third party
supplies in this machine. If you want
to continue, select [Next].
—
The phone receiver is off
the hook.
— Put down the receiver. —
The slit glass requires
cleaning.
— Clean the slit glass. page 10-3
This memory is not
formatted.
This will be formatted.
Are you sure?
Is the removable memory formatted
by this machine?
Perform [Format] on this machine. —
This user account is
locked out.
— Contact administrator.
Job is canceled. Select [End].
—
Message Checkpoints Corrective Actions
Reference
Page
To Next Page
Loading...
Need help?
General
