8-12
Setup and Registration (System Menu) > System Menu
SMB Select whether to send documents using SMB. When selecting [On], set the SMB default Port
Number. The default port number is 445.
Value: Off, On (Port Number: 1 to 65535)
SNMP Select whether to communicate using SNMP.
*1
Value: Off, On
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [SNMP] is set to [On].
Wi-Fi
*2
Wired Network
SMTP Select whether to send E-mail using SMTP.
Value: Off, On
POP3 Select whether to receive E-mail using POP3.
Value: Off, On
RAW Port Select whether to receive documents using Raw Port.
*1
Value: Off, On
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [RAW Port] is set to [On].
Wi-Fi
*2
Wired Network
LPD Selects whether to receive documents using LPD.
*1
Value: Off, On
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [LPD] is set to [On].
Wi-Fi
*2
Wired Network
IPP Selects whether to receive documents using IPP. To use the IPP protocol, select [Not Secure
(IPP&IPPS)] on IPP Security under Security Settings from the Command Center RX. The
default port number is 631.
*1
Value: Off, On (Port Number: 1 to 32767)
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [IPP] is set to [On].
Wi-Fi
*2
Wired Network
Item Description
To Next Page
Loading...
Need help?
General
