8-15
Setup and Registration (System Menu) > System Menu
Secure Settings
Ping
Restart Network
eSCL over SSL Selects whether to receive scanned documents using eSCL over SSL.
*1, *3
Value: Off, On
Wi-Fi Direct
*2
Set whether to enable this function for each network.
Value: Disable, Enable
NOTE
This function is displayed when [eSCL over SSL] is set to [On].
Wi-Fi
*2
Wired Network
VNC(RFB)overSSL This is set when starting up a VNC Viewer (E.g. RealVNC) to use Remote Operation
protected by SSL.
*1*3
The default port number is 9063.
Value: Off, On, 1 to 32767 (Port Number)
NOTE
This function is displayed when [VNC(RFB)overSSL] is set to [On].
Wi-Fi Direct
*2
Wi-Fi
*2
Wired Network
VNC(RFB) This is set when starting up a VNC Viewer (E.g. RealVNC) to use the Remote
Operation.
*1
The default port number is 9062.
Value: Off, On, 1 to 32767 (Port Number)
Wi-Fi Direct
*2
Wi-Fi
*2
Wired Network
EnhncdVNC ov SSL This is set when starting up Command Center RX to use Remote Operation protected
by SSL.
*1*3
The default port number is 9061.
Value: Off, On, 1 to 32767 (Port Number)
Wi-Fi Direct
*2
Wi-Fi
*2
Wired Network
*1 The setting will be changed after restarting the device or network.
*2 Displayed only when the wireless network function is available on the machine.
*3 Set "SSL" to [On] in Secure Settings.
Secure Settings
(page 8-15)
IMPORTANT
After changing the setting, restart the network or turn the machine OFF and then ON.
Item Description
SSL Select whether or not to use SSL.
Value: Off, On
Item Description
Ping Checks if communication with the destination by entering the host name or IP address of the
destination is possible.
Item Description
Restart Network Restarts the network.
Item Description
To Next Page
Loading...
Need help?
General
