Connecting and Printing 4-11
E-mail settings
By configuring the SMTP settings, you can send E-mail notifications on
completed jobs.
To use this function, this machine must be connected to a mail server
using the SMTP protocol.
In addition, check the following.
• The network environment used to connect this machine to the mail
server
A full-time connection via a LAN is recommended.
• SMTP settings
Use Command Center RX to register the IP address or host name of
the SMTP server.
• If limits have been set on the size of E-mail messages, it may not be
possible to send very large E-mails.
• The procedure for specifying the SMTP settings is explained below.
1
Access Command Center RX by referring to Accessing Command
Center RX on page 4-8.
2
From the Function Settings menu, click E-mail.
To Next Page
Loading...
