2P7/2R0/3PN-1
1-3-7
(41) Panel lock information F00: OFF
F01: Partial Lock 1
F02: Partial Lock 2
F03: Partial Lock 3
F04: Full Lock
(42) USB information U00: Not installed/U01: Full speed/U02: Hi speed
(43) Paper handling information 0: Paper source unit select/1: Paper source unit
(44) Auto cassette change 0: OFF/ 1: ON
(45) Black and white printing double
count mode
0: All single counts
1: A3, Single count, Less than 420 mm (length)
2: Legal, Single count, 356 mm or less (length)
3: Folio, Single count, Less than 330 mm (length)
*: The count mode can be changed using a PRESCRIBE
command.
When the double count is set for the paper other than the
sizes of A3, B4, A4, B5, A5, Folio, Ledger, Legal, Letter,
and Statement, the counter value is indicated as "Other 1"
in the status page. When in the same way, the single count
is set, the counter value is indicated as "Other 2". In the
operation panel, the counter values are indicated as "Other
1" or "Other 2".
(46) Billing counting timing -
(47) Temperature (machine outside) -
(48) Relative humidity
(machine outside)
-
(49) XLI calibration information -
(50) Beam A/BD synchronous fine-tun-
ing value
-
(51) Beam B/BD synchronous fine-tun-
ing value
-
(52) Fixed assets number -
(53) Job end judgment time-out time -
(54) Job end detection mode -
(55) PRESCRIBE environmental reset -
(56) Media type attributes
1 to 28 (Not used: 18, 19, 20)
* : For details on settings, refer
to MDAT command in “Pre-
scribe Commands Refer-
ence Manual.
Weight settings Fuser settings
0: Light 0: High
1: Normal 1 1: Middle
2: Normal 2 2: Low
3: Normal 3 3: Vellum
4: Heavy 1 Duplex settings
5: Heavy 2 0: Disable
6: Heavy 3 1: Enable
7: Extra Heavy
No. Description Supplement