System Menu > Device Common
235
MaintenanceAlert
[Menu] key > [ ][ ] key > [Device Common] > [OK] key > [ ][ ] key > [MaintenanceAlert] > [OK] key
Item Description
[Notify via Panel] Set whether or not to display on the operation panel when a periodic
inspection is near.
Value: [Off], [Display Status]
[NotifyExternally] Set the timing at which the administrator will be notified of the period
remaining before the upcoming scheduled inspection when it is near.
This notification is used for Event Reports, Status Monitors, and
SNMPTraps (such as Printing Equipment Management Systems).
Value
[Off/On]:[Off], [On]
NOTE
If [On] is selected, set the alert timing. The setting range is 5 to 100% (in
1% increments).
To Next Page
Loading...
Need help?
General