User Authentication and Accounting (User Login, Job Accounting) > Setting User Login Administration
252
Adding a User (Local User List)
You can add 1 user (including the default login user name).
1
Display the screen.
1 [Menu] key > [ ][ ] key > [User/Job Account] > [OK] key > [ ][ ] key > [User Login Set.] > [OK] key
NOTE
If the user authentication screen appears, log in with a user who has the privilege to configure this
setting. If you do not know your login user name or password, please contact your administrator.
2 [ ][ ] key > [Local User List] > [OK] key
2
Register the user.
1 [Menu] key > [Add User] > [OK] key
[Login User Name]
Enter the login user name to login (up to 64 characters). The same login user name cannot be
registered.
2 Select the [OK] key.
The User Name is “Power User”.
3
Enter the user information.
[ ][ ] key > [Detail]
[Login Password]
Enter the password to login (up to 64 characters).
[Access Level]
User access privileges are [User].
[Permit SysAdmin]
Select the privileges that can be set from the following.
• User/Job Account Information
• Basic Network Settings
• Advanced Device/Network
4
Select the [OK] key.
The user information is configured.
Changing User Properties for Local Users
(Admin, DeviceAdmin, PowerUser)
Types of user properties that could be changed may be different depending on user access privilege.
To Next Page
Loading...
