Kyocera ECOSYS PA4500cx - Page 221

System Menu > Network
214
[POP3]
[RAW Port]
[LPD]
[IPP]
Item Description
[Off/On] Select whether to receive E-mail using POP3.
Value: [Off], [On]
Item Description
[Off/On] Set whether to receive documents using the Raw Port.
The setting will be changed after restarting the device or network.
Value: [Off], [On]
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Off/On] Set whether to send documents using LPD.
The setting will be changed after restarting the device or network.
Value: [Off], [On]
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]
Item Description
[Off/On] Set whether to send documents using IPP. To use this, select [On] for
this setting, and select [Off] for [TLS] in the [Security]. Then select [Not
Secure (IPPS & IPP)] in the security settings from Command Center RX.
The default port number is 631.
Value: [Off], [On], 1 to 32767 (Port Number)
[AvailableNetwork] Set whether to enable this function for each network of Wi-Fi Direct,
Wi-Fi and wired.
Value: [Disable], [Enable]