Troubleshooting > Troubleshooting
321
While [Auto-IP] is already set to [On], the IP address is not
assigned automatically
Is a value other than "0.0.0.0" entered for the link local address of TCP/IP(v4)?
1
Enter "0.0.0.0" in IP Address of TCP/IP(v4).
1 [Menu] key > [ ][ ] key > [Network] > [OK] key > [ ][ ] key > [Wired Netwk. Set] > [OK] key >
[ ][ ] key > [TCP/IP Settings] > [OK] key > [ ][ ] key > [IPv4 Setting] > [OK] key
2 Enter "0.0.0.0" in IP Address.
➡ TCP/IP (IPv4) setting (page 46)
To Next Page
Loading...
