Troubleshooting > Troubleshooting
349
"Replace XXXXX" is displayed
Contact your service representative.
After replacing the parts, follow the steps below:
1
[Menu]key > [ ][ ]key > [Adjust/Maint.] > [OK]key > [ ][ ]key > [Maint(Cass1)]
to [Maint(Cass5)] > [OK]key
"Replace the toner. [C][M][Y][K]" is displayed
Replace the toner container to our specified toner container.
NOTE
If there is still black toner left even after color toner has run out and [ColorToner Empty] is set to [Print in B & W],
black and white printing is possible temporarily.
CAUTION
Do not attempt to incinerate parts which contain toner. Dangerous sparks may cause burns.
Installation procedures of the toner container is same for every color. Here, we'll explain the procedures for the
yellow toner container, as an example.
1
Open the top cover.
To Next Page
Loading...
