Job
8-15 KX Driver
name is the same as the document name. To remove the application name, select
Don’t use application name.
4 Click OK. 4
5
When you Print from the application, the job will be saved to the hard disk while the
specified number of copies prints. 5
Print Additional Copies of Quick Copy Jobs
Note: The actual key sequence may differ depending on the model.
1
Press the MENU key at the printing system’s operation panel. 1
2
Press the S or T key repeatedly until e-MPS > appears. 2
3
Press the X key to open the submenu. 3
4
Press the S or T key repeatedly until >Quick Copy appears. 4
5
Press the ENTER key. A blinking question mark [ ? ] appears by the user name. To
set a user name, follow the instructions in Identification on page 2-4. 5
6
If the user name is correct, press the ENTER key. Otherwise, press the S or T key
until the correct name appears. 6
7
Press the ENTER key. 7
8
The job name appears with a blinking question mark [ ? ].
If this is the correct job for printing, press the ENTER key. 8
9
Otherwise, press the T or S key until the correct name appears. Then, press the
ENTER key. 9
10
Press theT or S key to specify the number of copies. 10
11
Press the ENTER key. The Quick Copy job is reprinted in the specified number of
copies. 11
Delete Quick Copy Jobs
1
Refer to steps 1 through 8 in Print Additional Copies of Quick Copy Jobs on
page 8-15. 1
2
If this is the correct job for deletion, press the ENTER key. 2
3
Otherwise, press the T or S key until the correct name appears. 3
4
After the menu for specifying the number of print copies appears, press the T key
once. Delete appears. 4
5
Press ENTER to delete the job. 5
To Next Page
Loading...
